Edelbrock 600cfm Carb - $50

Locked
User avatar
DRIVEN
Posts: 7633
Joined: Thu Jun 27, 2013 7:05 pm
Location: I've been everywhere
Has thanked: 1167 times
Been thanked: 1138 times

Edelbrock 600cfm Carb - $50

#1

Post by DRIVEN » Sun Nov 02, 2014 9:31 am

Edelbrock #1406 with electric choke.

First things first -- The corner of the base has a crack. Fractured but not broken or even loose. I believe it can be repaired but it actually ran pretty well. Didn't even realize the crack was there until I snugged down the nut on that corner and it began to idle poorly. Loosened the nut back up and it smoothed out. When I told the owner of the car about it he wanted me to replace it with a new carb.
Personally, I'm not a huge AFB fan so I'll probably never use it. If I planned to, I'd probably grind the crack out with a Dremel and fill it with epoxy. You can do as you please. It's a runner but being priced as a parts carb. New replacement cost is $325-ish. Electric choke conversion kits are $60 alone.

$50 firm.
Trades may be considered.
Image
Image
Image
Last edited by DRIVEN on Sun Nov 16, 2014 5:11 pm, edited 1 time in total.
When the only tool you have is a hammer every problem starts to look like a hippy.

User avatar
DRIVEN
Posts: 7633
Joined: Thu Jun 27, 2013 7:05 pm
Location: I've been everywhere
Has thanked: 1167 times
Been thanked: 1138 times

Re: Edelbrock 600cfm Carb - $50

#2

Post by DRIVEN » Sat Nov 15, 2014 8:51 am

TTT
When the only tool you have is a hammer every problem starts to look like a hippy.

User avatar
DRIVEN
Posts: 7633
Joined: Thu Jun 27, 2013 7:05 pm
Location: I've been everywhere
Has thanked: 1167 times
Been thanked: 1138 times

Re: Edelbrock 600cfm Carb - $50

#3

Post by DRIVEN » Sun Nov 16, 2014 5:10 pm

Sold!
When the only tool you have is a hammer every problem starts to look like a hippy.

Locked