New World Datsuns...

Haha, I dont know how to do all that. Im using the sheet metal from the roof of a 510 sedan, it was a donor car for my brothers racecars.

I want to figure out how to do that, making 510 LHD SSS dash pieces...

That would be awsome. You can teach me. I know a guy with a table and experiance.... hes a h3 guy tho... hard to hang with lolol

Holy mother of god........

Taped this up like 10 times, its alittle off here. But you get the basic idea.
Little big huh.

If anyone can make that work...

Haha. Well I figure, im out nothing if I dont like it. Cutt em off and try again.... what am I going to f up lolol

And while this car will not leave my possesion, my parts car. (The hidden orange sedan) is now promoted to the "nice one" so this car is for the most part a free for all.

Wich means I can go even lower than planned!

The more I think about it, the more they bother me. Im going to tach some patches in tomaro, and see if I can work something different/smaller/more shapely into the flares.

We need you to slow down and contemplate your actions. You're getting into some awkward and dangerous territory... http://community.ratsun.net/topic/43042 ... -widebody/

...just sayin.


Honestly, if it were mine, I'd probably just slather them back up with bondo and smooth them out like stock. Cover them in paint like the last guy did and try to forget it's there.

I cant/wont do that. I have been contenmplating tho..

Ive got like 23 days, so. Whatever I do will be a rash decision.

I say go for it. Mad phat FWD 710 widebody with rainbow bright painted on the side. you got this shit.

Fuck that. Donk that shit!

Those arches would be perfect for a set of 28s, yo.

^^That would certainly get plenty of attention at Canby...and en Woooodburn.

I would rather cutt it in half and make it into 2 rusty couches than to donk it.
Started making some patches, so I can get away with smaller flares, if I have enough time.

One down. 10 dozen to go...... it would deffenatly be easier to give this thing away and move into a cave and shove rocks up my bum. But I dont know of any good caves.

So, spent what little money I had to slap this car together to drive out and get these.

They were off a car I had, but I gave em to a guy, he reluctantly gave them back, but they still have some pinn holey stuff.
Got inside the car the weld the lower rocker/arch brace in, it shifted a bit but idc, ill hammer the bottom corner into position
Now I want to try and patch these arches.
But I also gotta get some $ flow.

I couldnt replace as much as I should. Couldnt get to alot of it cause the quarter. Ill have to make rockers eventualy.