New World Datsuns...

I like this solution better.

X2^^^

I have a fealing this would turn out alot better if I was doing it INSIDE..... no where indoors to doit tho.

Good to see you going this route; would be a shame to give up on the old girl.

Is this the bbq....







Cause I brought the meats!



215/50r13s nicka!

I needed some sort of instant gratification so I removed the rear bumper.

It wa short lived when the tail pan started falling out in chunks.

I got a wire wheel all up in this bitch today,


Then I was going to tack some patxhes in. But it was just to damn windy outside(where I weld .. )
So instead I dexided to make a tunnel for my edlebrock muffler, wich is one of the most compact mufflers ive had, but then I was all. "Wait.... rusty as fuck beater car..... " so I just thru the jack under it and made some room for it.

to bad your not closer. A 76 710 just showed up at the Spokane P&S in the valley.

FS318 A08 JHL710096434 1976 Datsun 710 New

http://www.spaldings.com/includes/pnslo ... ch+%28*%29

Damn!

Spokane... Thats where HRH is... Maybe a PM to him via rassun? Would be worth askin at the least...

Spent what little cash I had to run out to dufur and get these patch panels. Super broke now.

Wasnt raining today, so even tho my baxk was killin me I fitted a few patch panels.

Grinding away mm by mm.

Almost done fitting this side.

From super cool. to clapped out rusty parts car, on its way back to super cool.

Fuck yeah dude. Good job savin it! These don't show up often.

I need to do some extensive rolling to fit my wheels, but im afraid to before I weld em, and im afraid to after I weld them.
But I have a few ideas. Hope I can figure it out. Got some tubing (my brother greasemonkey got it for me) so I can secure the chassi up some, little nervous after the rust ive found.

Nice stack

New seats, new valves, changed my mind on what to do several times, who wanna see?

raises hand...

This guy.

Me Three