New World Datsuns...

Thank's guys!

bajasdogs » Fri Jul 18, 2014 1:38 pm wrote:Hi! My name is mike and I'm new to the group and sure could use a few parts for my daily driver.

What are you looking for?
I'm going to head up and look at some vehicles (210,222) on 8/2. I'm looking to buy a few parts myself.
Well, that's the plan anyways.

bajasdogs » Fri Jul 18, 2014 12:38 pm wrote:Hi! My name is mike and I'm new to the group and sure could use a few parts for my daily driver.

Welcome to NWD Mike
Cool truck

bajasdogs » Fri Jul 18, 2014 1:46 pm wrote:Thank's guys!

Need MOAR pics of your truck!!!!!!!

Sorry I got lost on the internet! I could use a lot of parts really. A seat, back bumper pieces. Decent wind wing rubbers a choke pull button. A vent lever, Wiper Arms, A tight front axle, Brake drums, Good rear wheel cylinders, A one bbl carburetor, Battery hold down, A side mount antenna for the fender, Rear view mirror, An original radiator cap. Need I go on? A whole truck would be great! LOL! I think I have pictures uploaded on Yahoo, I'll post them soon!

Actually this truck is only missing the seat, back bumpers, vent pull the choke knob, battery holder, A front turn signal lens and could use a tail lens, headlight rims and a radiator cap. It had the original thermostat installed and shock absorbors when I bought it. I'm working on King Pins but the only ones I can find are .0016 over so I'm going to have to do some reaming. I have welded a 1" strip in both rocker panels about 3/4's of the length and replaced around 4 square inches in the front door post while retaining all the original corners and welds. The back edge of the fenders was full of pin holes but other then that this one had very little rust. I had to weld up pin holes in the original gas tank as the extra only held 5 gallons. This one now has a 13 gallon capacity! I could use a fuel cap inset off an old discarded bed to integrate the extra filler spout just a bit better. All the rubber needs replaced. I'll get to that soon.

that truck is so cool!!

That's One Very Cool Old Datsun!

Is this truck for sale and how do I contact the owner?

Hi my name is John fromOhio.I'am new to this site. I have two 1960 Datsun trucks I'am restoring. I could use some hub caps ,side mirrors ,tail lights,side Crome strips,radiator,windshield ext.If there is anyone out there that may be able to help me please let me know.Thanks.

Welcome to NWDatsuns John

I wan to see one in person. Curious how much smaller it is than the 521 or even a 320.

Datsunburg » Mon Oct 26, 2015 2:15 pm wrote:Hi my name is John fromOhio.I'am new to this site. I have two 1960 Datsun trucks I'am restoring. I could use some hub caps ,side mirrors ,tail lights,side Crome strips,radiator,windshield ext.If there is anyone out there that may be able to help me please let me know.Thanks.

Jefe may have some stuff. Hang tight, I'm sure he will chime in.

flatcat19 » Mon Oct 26, 2015 8:49 pm wrote:I wan to see one in person. Curious how much smaller it is than the 521 or even a 320.

The 221 seems to be about the same as a 320, not a lot of room in there unless you are a small person.