New World Datsuns...

DRIVEN wrote:

510freak wrote:Nice,free up some bucks for some rear tires

Fixed^^^

Now,I have to go find some likes,they be there in a minute

Now what makes you think I'm gunna need rear tires?.......

I hate the waiting game........



But all I have left is:

a new drive line
Header(if the one I have doesn't fit)
Convince my self to buy an aluminum rad
And small stuff like hoses and fluids

Why buy aluminum radiator? Unconvincing needed?

I want to buy al aluminum rad for 2 reasons

A. It's sexy
B. less rad hoses in the bay

Eagle_Adam wrote:I want to buy al aluminum rad for 2 reasons

A. It's sexy
B. less rad hoses in the bay

you forgot one:
C. Aluminum is almost 2X more thermo-conductive than the Copper brass (70% Cu, 30% Zi) rads are made of.

Good, or bad, thats the vicious nature of obsession. With every improvement there's more reason for doing other improvements. IMHO, There's one place that sickness should always go untreated, and that's under your hood.

Just a heads up, make sure to either insulate the rad from ground, or use distilled water to avoid electrolytic corrosion.

for testing your cooling system, check this out http://www.rondavisradiators.com/tech.htm Bottom of the page.

and i bought a few new toys............. this is what happens when i get $ that isnt from my paycheck.....





soooo



sounds like this weekend i will be redoing the front brakes/wheel bearings on my dads 67 mustang and assembling my KA!!!!!!!

you going one piece driveline in this?

SI!!!!!!!!

hahaha i saw dat in the other thread.... Good man. I have a one piece in my 720. Its so much easier.

Should asked to borrow those tools. I has them, but I have no idea what the one in the middle does.

middle one cleans out the ring groves on the pistons



and ya i coulda borrowed them but at this point i might as well own them....

this page lacks pics adam lol

bonvo wrote:this page lacks pics adam lol

X2

But I've posted 2 pics.....

Laecaon wrote:I has them, but I have no idea what the one in the middle does.

It's a B=Dazzl'r. I just did my denim jacket all rad with one.
I put a dragon on it!


















Kidding. Progress is awesome.
You may have this done before I even make it back there.

today and tomorrow are gunna be like freekn Christmas!!!!!!

rings
bearings
piston tools
centerlink
idler arm
ring filer

all come in today or tomorrow!!!!!





and i bought anohter DE head for $30!!!!!!!



dud said it was "too rusty to run"



thats the rust he said made the head trash....



SCORE!

shit. relap those valves, done.

or a spare head to have lots of work done to then swap onto my current motor will little to no down time

BAM!

cams
port
polish


HAPPIER adam

got a few presents in the mail today!

all my piston ring tools - not so sure im happy with my decision on the piston ring clamp but i guess ill have to try it





and on top of all that i got my cooling system figured out(big thanx to benjammin)

the fan:





the controller:
http://www.ebay.com/itm/200953005411

the rad:
http://www.ebay.com/itm/Fits-MAZDA-RX2- ... 68&vxp=mtr