New World Datsuns...

I think that depends a little on the drivetrain... and a little on cash flow...

If you ask me? No I don't think it or myself will be at canby. If you ask Adam? Yeah he seems to think it and myself will be attending this year. We will see how things go. Still need to sort out a few things before it will move under it's own power once the motor and trans is in. Need to get a trans mount, driveline sorted out, would like to do the clutch before the whole thing goes in but it will have to wait. Little things that stack up to a big thing.

I understand man

When you got the time, you don't got the money. when you got the money.. you don't got the time... on rare occurrences both happen


Hope to see you there at least.

Brown wrote:If you ask me? No I don't think it or myself will be at canby. If you ask Adam? Yeah he seems to think it and myself will be attending this year. We will see how things go. Still need to sort out a few things before it will move under it's own power once the motor and trans is in. Need to get a trans mount, driveline sorted out, would like to do the clutch before the whole thing goes in but it will have to wait. Little things that stack up to a big thing.

If you have Adam on your side, anything can happen.

found you a driveline and motor mounts yo!!!!

should be pulling ur motor in less than a week

Motor mounts in hand!!

And then there was this


And more of this


And yet more strippers


So many layers of paint :/

Eagle_Adam wrote:

Me in my natural state.,.... PBR in hand..

Even got Zach and Levi to help today




Got the dash taken apart, cleaned of the dead bee's and bee hive....





Much better




Not a bad day

Dude, your rear quarter panel looks exactly like mine .. Why do 510's always get smacked in one of those two back corners..

Because fuck tailgaters....

At the rate you guys are going it looks to me like you'll be at Canby.

at this rate only my GF's goon will make it to canby

once i get home its fucking game on!

gotta pull brandons motor and trans
part out and scrap a 620
finish building my KA
install my KA/5speed swap
wire the swap and DZ start in
install a motor and trans into brandons car


then make another list of to do's and get started praying i can get all the cars to canby




sounds like last year

Rubber Motor mounts
Trans mount
Drive line
Radiator

All taken care of now

I find it funny that you update my thread more then I do adam lol. I guess i just never think about it or really take pictars..

Off to Eugene!!


See ya there Brandon

Bam!

can't tell from photo too well. Looks like Xmember still needs installed for tranny. Coming right along mang... It's funny how messy the fucking engine bays are.. .Till you get everything hooked up.. then it just kind of cleans itself up

izzo wrote:can't tell from photo too well. Looks like Xmember still needs installed for tranny. Coming right along mang... It's funny how messy the fucking engine bays are.. .Till you get everything hooked up.. then it just kind of cleans itself up

yeah the engine is just sitting in there. no mounts or trans cross member installed yet. Going to do that later today. lol.