New World Datsuns...

A buddy hooked me up with this
Piece of awesome

I finally got my garage back!

And in doing So obtained patch panels for the only rust on my truck, also got someone to weld em in for me down the road

And while I was cleaning up jessi got my metal glove box insert installed!

Ordered it from "rods mods" on FB if anyone want contact info lemme know



Dropped right in no problems and it's TITS!

Made some real progress today, ended up here



But not before stripping out a cam tower bolt, and snapping another bolt in my timing cover....


So now I'm a set of pliers to remove the fuel injectors, some fresh wire brushes, and a helicoil away from being
Ready to drop it in the engine bay!!!

Anyone near Portland got a cherry picker I can borrow for an afternoon?

To do:
Helicoil stripped cam tower bolt
Install upper timing cover
Clean and install fuel injectors and rail(may have to buy new injectors :/)
Clean and install Throttle body(any tips welcome)
Find cherry picker or go to Eugene and pick up mine

Did you brake kleen your engine bay?

Not yet..... Might start with a pressure washer this time

Expanding tire foam does wonders cleaning a funky engine bay.

Sure looks like a motor, wish it would rotate like a damn motor.....

mmm sexy.

I'm staring hard like a retard! Bahhaa

Much better!!!!


Click for the vid


















Pouring oil down the spark plug holes did the trick!

SOrry if i missed it.

What's the plan with the wagon from bend? And is that going to delay this? Or you gonna do tricks and mash out two cars at once again

Go check the tread for it Izzo

And this one gets done before any of the rest do.....


Or I start getting violent

Eagle_Adam » Tue Jul 29, 2014 10:15 am wrote:Go check the tread for it Izzo

And this one gets done before any of the rest do.....


Or I start getting violent

You mean you want me to go read your build thread? WHAT'S THIS WORLD COMING TO?!!!?!!111skeet!! lolol.


I'll go look at the "tread"

I would never ask you to do something like that Izzo!!!














:p












since all is well I'm on to the emissions delete and assembly of the install mani.

Once those are done and the transmission has been pressure washed I can drop the motor and trans in for The first time


For anyone interested this is a badass written up on emissions delete and intake manifold assembly
http://www.nicoclub.com/archives/intake ... embly.html

Bookmarked for future use.

Well this confusing mess is sorted












I think...

Looks just like the link man. Should be good to go? Tho i didn't look that hard


Is it in yet

If all goes well it should be sitting in the engine bay before I go to bed!

Lol... Give it to that truck REAL GOOD.


Sucks I gotta wait till god knows when to see the pictars Wish I lived closer.