Page 1 of 1
WTB Z22 crankshaft and Z20E rods.
Posted: Thu Jul 04, 2013 11:56 pm
by Kirden
Looking for a Z22 crank and Z20E rods to finish up my engine build. Parts would need to be shipped to Macon, GA 31211. I will have L20B rods, pistons, and a crank once I tear down the block if those are needed in trade, but I prefer to keep them for future use.
Re: WTB Z22 crankshaft and Z20E rods.
Posted: Fri Jul 05, 2013 12:07 pm
by datsunmike
That's a 6" or 152.5mm long rod as measured from the center of the crank to the center of the piston pin. Just take the rod cap off and stand up on a table. Use a (metric) tape and measure from table to the middle of the pin hole. Your eye will be close enough.