Adam's annoying ass green 620

[MicroMachinery]

Too bad gas tanks aren't like ping pong balls.. toss a dented one into some boiling water and voila!

[Spoona_Jay21]

Too bad gas tanks aren't like ping pong balls.. toss a dented one into some boiling water and voila!

why wouldn't it work? fill it 3/4 of the way full with water, if it has a good sealing cap put that on, and make sure to plug all the other lines reeal good, and let it boil. eventually enough pressure would build up and it should pop.

Talkin out my ass, and it is only theory, but it never hurts to try.

[flatcat19]

Heat it up really good then blast it with cold air. Like a fender dent.

[MicroMachinery]

Too bad gas tanks aren't like ping pong balls.. toss a dented one into some boiling water and voila!

why wouldn't it work? fill it 3/4 of the way full with water, if it has a good sealing cap put that on, and make sure to plug all the other lines reeal good, and let it boil. eventually enough pressure would build up and it should pop.

Talkin out my ass, and it is only theory, but it never hurts to try.

You'd probably have to weld it up to get that good of a seal.

[Spoona_Jay21]

Too bad gas tanks aren't like ping pong balls.. toss a dented one into some boiling water and voila!

why wouldn't it work? fill it 3/4 of the way full with water, if it has a good sealing cap put that on, and make sure to plug all the other lines reeal good, and let it boil. eventually enough pressure would build up and it should pop.

Talkin out my ass, and it is only theory, but it never hurts to try.

You'd probably have to weld it up to get that good of a seal.

I can see that. as said, just a theory.

[Eagle_Adam]

too late guys, its already installed and im over it






























or so i keep telling myself

[flatcat19]

You will have a bad dream involving that tank.

[Eagle_Adam]

Still kicking myself flatcat......


But
Ill just leave this here

[izzo]

Hory shet dude. That's ..... fuck i don't even know what to say. Do like, do want.

[Eagle_Adam]

These went in the rear



And these went in the front



Took these out


Next up:
Finish the centerlink flip

[flatcat19]

Are you flipping the link?
Should fit the 240sx pan that way? At least that is what I have read.

Progression kicks ass!

[Eagle_Adam]

Are you flipping the link?
Should fit the 240sx pan that way? At least that is what I have read.

Progression kicks ass!

yup, gotta fill in the holes for the centerlink and reverse the taper to clear the oil pan

[Eagle_Adam]

and it looks like the last piece of powder-coating is done!!!



hopefully i can wrap up the front end tonight, then its will be the goons turn in the garage for the weekend

[Eagle_Adam]

frame notches......


sure why not!

[DRIVEN]

Thought those were rod bearings when I scrolled down the page.

[Eagle_Adam]

sitting at work not being able to open this box is killing me......

[draker]

Is that a jrock box?

[Eagle_Adam]

yes........ yes it is!

[Eagle_Adam]

and this is what it held
well thanx for lunch.....



but this is what i really wanted, and boy is it yummy!



lower timing cover to match the block


crank pulley


oil pan to complete the black bottom end


silver upper timing cover to match the cyl head



water pump pulley



valve cover


motor mounts



and last but not least, a set of grill trim rings!!

[draker]

Wow.. impressive! That engine is going to be cleeeeeeeaaaaan!