WTB Z22 crankshaft and Z20E rods.
WTB Z22 crankshaft and Z20E rods.
Looking for a Z22 crank and Z20E rods to finish up my engine build. Parts would need to be shipped to Macon, GA 31211. I will have L20B rods, pistons, and a crank once I tear down the block if those are needed in trade, but I prefer to keep them for future use.
-
datsunmike
- Posts: 554
- Joined: Sat Jun 29, 2013 1:07 pm
- Location: 49. 37. 124. 75
- Been thanked: 1 time
Re: WTB Z22 crankshaft and Z20E rods.
That's a 6" or 152.5mm long rod as measured from the center of the crank to the center of the piston pin. Just take the rod cap off and stand up on a table. Use a (metric) tape and measure from table to the middle of the pin hole. Your eye will be close enough.
My Datsuns, like good friends, have never let me down. At least in any way that was not understandable and thus fixable.