the mine now coupe.

[RedBanner]

[izzo]

damn dude. Looks very good under there! takin it for a spin yet?

[Draynor]

Awesome

[RedBanner]

Back and forth in the driveway, waiting for breakpads to come in tomaro.

[izzo]

Jeez i bet the steering on that thing is more tight than a virgin

[RedBanner]

Taking her to prom tonight. Ill oet you know.

[Eagle_Adam]

wont be that tight ever again, enjoy her man she looked good

[RedBanner]

1200 guys will notice right away, talked about it alot, then did it. Never looking back.

[dislexicdime]

I bet it feelseven moe fun now. You gotta take me for a ride

[RedBanner]

...never mind the choke cables. Just making sure it fit. Lol. But close.

[RedBanner]

Was here, drove me nuts

[Morrisun]

Adam:
I love it! In contrast I am moving the wipers above the headlight switch and eliminating the cigar lighter altogether, non smoking car, that way I com operate manual choke with left hand while start switch is on the right. Mostly a left handed thing. I hope you pulled the dash loose? It a little tough for us XL guys to get underneath a 1200 dash! Your dash is looking great!

[RedBanner]

Yeah, I took the dash face loose, too sore to crawl backwards and upside down. Found a short, power was spliced out of the switch and rubbed on the brake pedal, so I pulled the face out a bit to run wire over the cluster. . Used factory plugfcand factory wires for a extension. So if I get over it it can swap right back.

[Gray]

Yeah, I took the dash face loose, too sore to crawl backwards and upside down. Found a short, power was spliced out of the switch and rubbed on the brake pedal, so I pulled the face out a bit to run wire over the cluster. . Used factory plugfcand factory wires for a extension. So if I get over it it can swap right back.

Always drove me crazy they swapped positions of the lights/washers between the 1200 and B210 especially when I would go from one car to the other. I'm so going to have to do something like this.

[RedBanner]

Cant tell from this pick but my car has SO much metal flake....

[RedBanner]

... in the oil

[Jamee]

[Laecaon]

Thats an easy one. Put magnets in the drain pan. it will keep the metal flakes from circulating!

[Mattndew76]

I love this coupe! Good buy.

[RedBanner]

Yeah I slapped 2 on the pan before I headed home last night. But it died on the way home, and locked up untill I dropped the clutch, its burnt. Ran fine the rest of the way home, but that webber screw I sucked thru #3 did some damage, 50# compression, and wet on cylender 3.still runs great over 3500 rpm, but is a total dog below that. It had big chunks on the dipstick.... the dip stick!
Have to drop this a 14 in it on friday or so.