
When I pulled some interior panels to run the wiring, I found evidence of past rodent activity. I pulled all the rear interior panels and scrubbed them down in bleach and hot water. Then went down to the car wash to vacuum everything before I put it back together. Much better now.


I installed the new all-weather mats, then pulled the console to swap the old power port for a new 3amp dual USB with volt gauge.


The last thing I did was run the wiring for the trailer lights and the 110v power inverter. I sent it down the passenger side rocker. The rubber bulkhead grommet fought me with a vengeance. I never would have been able to reach it if this was a V6 car.

I was out of time so I just coiled it at both ends. I'll finish it up when my 50A relay gets delivered.
